Guide: How To Jack Up A Dual Axle Travel Trailer

How to Jack Up a Dual Axle Travel Trailer

Travel trailers with two axles are a common choice for large, quick deliveries. There is virtually no concern that the items may be harmed in transit because they provide excellent stability even at high speeds. They can, however, have tire failure. Knowing how to jack up a dual-axle travel trailer is necessary in the event of a flat tire.  You can reduce the amount of damage a flat tire may do and guarantee easier deliveries by being well-prepared.

Required tools

The following list of necessary tools will help you effectively jack a trailer with two axles.

Car ramp

It is never a good idea to jack up your dual axle trailer using bottle jacks or jack stands. Experts advise against utilizing them with travel trailers due to their difficulty in usage. Furthermore, the trailer’s weight could be too much for them to manage. Since a tire ramp is made especially for large trucks, it’s the greatest substitute for normal ramps. Tire ramps are simple to use and don’t need much effort to start going.

An Extra Tire

It is basic to have an additional tire, especially while making a trip to a distant spot. It would help if you didn’t go with your trailer on the off chance that it doesn’t have an extra tire.

A Wrench And Socket

This is a necessary tool that will make it easy for you to eliminate and tighten nuts and bolts.


Lubricants not only facilitate installation and demounting but also assist in shielding the rim from corrosion.

How To Jack Up A Dual Axle Travel Trailer?

How to Jack Up a Dual Axle Travel Trailer

You may jack up your dual-axle travel trailer in a variety of ways. Certain techniques are quite simple, while others may be challenging if you lack the necessary equipment.

Here is a step-by-step technique for jacking up your trailer.

Place Your Trailer In A Safe Spot

You must park your trailer on a level, safe area. If at all feasible, park your vehicle on a level surface or, in the event of inclement weather or rain, in a place where you may drive off-road and pull over at an angle. In this manner, even if the jacks are not positioned correctly, the trailer won’t move off them.

Jack Stands Should Be Placed Under Your Travel Trailer

The jack stands will then need to be positioned. Verify that they are situated just safely to the point of staying, but not so firmly that eliminating them sometime in the not-too-distant future will be difficult.

The Tire Ramp Should Be Placed Under Your Travel Trailer

The tire ramp should then be positioned in front of the inflated tire. This will provide you with a secure platform for trailer jacking. Additionally, it guarantees that while jacking up, your jack stands won’t become lodged in the wheel well.

Put On The Parking Brake And Handbrake

Before jacking up, engage the hand brake on your trailer. Even though it’s not needed, it will help keep the trailer from moving while you’re under it. Ensure you draw in the stopping brake on the trailer as well.

Lift The Trailer

It’s time to lift your tandem axle trailer now that you have positioned your jack supports, tire ramp, and jacks. A jack stand should first be inserted into the wheel well (on both sides). As needed, elevate it with your hydraulic jack; only watch that you don’t increase it to the point where the jack reaches its maximum height.

Replace The Tire

You may change your flat tire after the trailer has been raised. To remove the tire, you might have to pull it off the rim. To remove the tire, just slide your floor jack behind the axle and use your wrench and breaker bar to undo the lug nuts on either side. After positioning the spare tire on the rim, firmly tighten the lug nuts.

Take Down The Jack Stands And Lower Your Travel Trailer

It’s time to remove your jack supports and lower the trailer back to the ground when you’ve completed replacing your tire. To take down the stands, just do the opposite of whatever you did when you jacked up your trailer. Verify that the lug nuts are properly tightened.

Advice And Warning

To properly jack your Dual Axle trailer, you must bear in mind the following advice and warnings:

Use The Correct Jack

The market is inundated with many kinds of jacks, but only a handful of them are suggested for jacking a Dual Axle Travel Trailer. The finest tool for jacking a trailer is the tire ramp, as was previously indicated.

Replace Your Tire In A Safe Spot

Never change a flat tire on a busy road or highway; instead, change it in a safe place. Before replacing your tire, move to a secure location with less traffic.

Always Pick An Additional Tire

Since no one can tell when you’ll require an extra, it’s smart to keep one in your trailer consistently.

Ask For Assistance

See, you don’t have to accomplish everything by yourself. You might ask other people you are with to assist you in indicating when the tire is on the ramp.

Make Sure You Use A Jack For The Intended Purpose

Raising a car off the ground. Hold off on using it for other things.

Block The Front Wheels

It’s crucial to block the wheels before jacking the car if you intend to use a bottle jack. Doing this can prevent the car from rolling as you begin to jack it up.


By following these easy procedures, you may safely jack up your trailer and reduce the chance of harm. We hope that this post will assist you in jacking up your trailer so that you can fix a flat tire anytime you’re on the road. You will need to practice jacking up a dual-axle trailer often after learning how to do it the first time. You will get better at it and be able to do more with your trailer as you practice more. These kinds of new abilities are enjoyable and practical; therefore, you should constantly try to pick them up.

Thanks for visiting our Blog Post. Please visit the relevant category for more related Content.


Leave a Reply

Your email address will not be published. Required fields are marked *